How to Fit a Velcro Plaid Dog Bandana So It Stays Put
By Dog & Cat Beds, Crates & Supplies|Free US Shipping Loaf & Wag | Published: 2026-11-01
Category: How-to Guides
A velcro plaid dog bandana only looks sharp if it stays put. Measure the neck, place the closure correctly, and use these steps to stop slipping and bunching.
Quick answer
Measure your dog’s neck at the base where the bandana will sit, choose a size with at least an inch of velcro overlap, and fasten the closure snug but not tight. Then check that the bandana stays above the shoulder blades and doesn’t twist when your dog moves.
Why velcro bandanas slip (and when they won’t)
Velcro holds best when the hook and loop strips meet flat and fully. A bandana slips when the neck measurement is between sizes, when the velcro barely overlaps, or when the fabric is too loose and shifts forward. Thick or long fur can also reduce grip because the closure sits on hair instead of the bandana.
A plaid bandana with an elongated velcro enclosure gives you room to adjust, but it still needs a starting measurement. If your dog is between sizes, size up only if the velcro can overlap by at least an inch; otherwise size down.
Two ways to wear it: neck vs. head
Some velcro bandanas can be worn around the neck or on the head. For everyday wear, the neck position is more secure and less likely to slide. The head position works for photos or short outings but may need a tighter fit and more frequent checks.
If you switch between positions, re-measure each time. A fit that works around the neck may be too loose on the head.
Step-by-step fit for a no-slip velcro bandana
- Measure the neck at the base: Use a soft tape measure around the widest part of the neck where the bandana will rest. Keep the tape snug but not tight. Write down the measurement in inches. Measure at the base of the neck, not up near the ears.
- Choose the size with enough velcro overlap: Compare your measurement to the size options. Pick a size where the velcro strips can overlap by at least one inch when fastened. If you’re between sizes, size down unless the next size up still allows that overlap. Velcro needs overlap to grip; a loose bandana will slip.
- Place the bandana above the shoulder blades: Center the bandana on the back of the neck so the point hangs down the chest. The top edge should sit just below the collar line, not on the throat. A bandana that sits too low will slide forward when your dog sniffs the ground.
- Fasten the velcro flat and snug: Press the hook and loop strips together firmly, making sure they align edge to edge. The bandana should feel secure but allow you to slide one finger under the closure. If you can’t slide a finger under, it’s too tight; if it slides off easily, it’s too loose.
- Test movement and adjust: Walk your dog, ask for a sit, and watch for twisting or slipping. If the bandana shifts, refasten with more overlap or try the next size down. Always recheck after a few minutes of movement.
- Check fur and comfort: For long-haired dogs, part the fur so the velcro sits against the bandana, not the coat. Remove the bandana if your dog scratches at it or seems uncomfortable. Never leave a bandana on an unsupervised dog.
Product facts
- Touchdog Plaid Patterned Fashionable Velcro Bandana: Elongated Velcro enclosures leave room for growth and adjustability. That extra overlap lets you fine-tune the fit as your dog’s coat changes or between sizes.
Touchdog Plaid Patterned Fashionable Velcro Bandana - Touchdog Plaid Patterned Fashionable Velcro Bandana: Can be worn two ways: on the head or around the neck. You get more styling options, but each position needs its own fit check to prevent slipping.
